What sizes does Hardie trim come in?
Available in commonly-used nominal widths from 101mm (4 in) to 304mm (12 in). HARDIETRIM® BATTEN BOARDS HardieTrim® Batten Boards are a decorative non-load bearing trim product. HardieTrim® Batten Boards are 19mm (¾ in) thick, 64mm (2½ in) wide, and come on 3,658mm (12 ft) lengths.
How much does fiber cement trim cost?
Fiber Cement Trim Cost These materials are all priced by the linear foot and cost between $1.50 and $4 a linear foot on average, depending on the material, finish, and style.
Does Hardie board make trim?
James Hardie offers a variety of trim sizes options to pair with your chosen James Hardie fiber cement siding.
Is Hardie trim discontinued?
In August of 2021, suppliers and contractors were notified that James Hardie Building Products is intending to permanently stop manufacturing all Hardie Trim products for select markets.
How do you cut Hardie board trim?
When it comes to cutting these products, the process is the same for both the trim and the siding.
- Install the HardiBlade saw blade in the saw.
- Measure the area where the trim piece will go.
- Mark the piece of trim to cut.
- Place the trim in the saw and adjust the saw to create the proper angle for the desired cut.
Can you put Hardie board over wood siding?
Does Existing Wood Siding Need to Be in Decent Condition to Cover With Hardie Board? Absolutely. It is very important that, in addition to being flush and flat, wood siding needs to be in decent condition to be covered with Hardie board.
What is fiber cement trim used for?
Fiber cement siding is a durable, long-lasting and low-maintenance material that’s used on residential houses and some commercial projects. It’s a semi-rigid material that provides substantial protection, while still maintaining some flexibility.
Can you use screws on fiber cement siding?
Fiber cement siding can be nailed by hand or with a pneumatic nailer. It can also be attached using corrosion resistant screws. Use hot-dipped galvanized or stainless steel nails.
What nails are used for Hardie trim?
James Hardie recommends using stainless steel finish nails when installing HardieTrim products. Use a 2 in. finish nail to fasten trim together. Longer finish nails may bend.
Can you use Hardie board as fascia?
HardieTrim board is a decorative non-load bearing trim product. Do not use HardieTrim to replace any structural component. HardieTrimboards can be fastened directly over a 2x sub-fascia or directly to rather tails.
Can you screw into Hardie trim?
Yes, you can drive screws into the Hardie board if you use suitable screws. Hardie Board requires using specific screws to work effectively. For best results, use ribbed stainless steel screws with wafer-head.
Do you need a special blade to cut Hardie board?
For some types of Hardie board, you’ll need a power tool with a cement board blade with a carbide tip to cut the board. Carbide-tipped blades are made specifically for this kind of work. Cut the Hardie board outside, because the dust released as the board is being cut can pose a safety hazard.