How do you use Bohning Ferr L tite Cool Flex hot melt?
Using Ferr-L-Tite® and Ferr-L-Tite® Cool Flex (hot-melt adhesives): Hold the insert/point with a pair of pliers and heat it over a small flame. Then heat the stick of adhesive with the flame until the adhesive glosses over (just before melting).
How do you use Ferr L Tite?
Place a generous amount of Ferr-L-Tite on the shaft tip that fits into the arrow point or broadhead. Using pliers, heat the arrow point until it is extremely hot. Immediately insert the wood shaft into the point so they fuse together. Insert is very hot – do not touch insert with bare hands.
Can I reuse arrow inserts?
Yes. You said, “Or you’ll cut into your inserts if you aren’t cutting enough length off, most inserts are longer then the one inch the OP needed cut off.” I said that you don’t need to cut all the way through or even into the insert.
How do you Fletch Bohning vanes?
BASIC FLETCHING INSTRUCTIONS: 1) Seat vane securely to the bottom of clamp slot/clip. Apply thin bead of Bohning glue to vane base. 2) Follow jig instructions for specific arrow shaft insertion, etc. Allow proper clamp time in the jig according to glue instructions.
How far should vanes be from Nock?
Easton website states”While there is some personal preference involved, Easton has found optimal performance by placing all factory-fletched arrows 1″ from the nock-end of the shaft to the start of the vane.”
Is Gorilla Glue good for arrow inserts?
GORILLA GLUE works great, and won’t crack from cold like some epoxy glues do. Personally I use the blue top for vanes and insert but hot glue for nocks, that way I can turn them if necessary to tune arrow or align my moon nocks after fletching if necc. I use the hot melt also.
Is super glue OK for arrow inserts?
Yes you can use super glue, in fact it is a really good option.
Can you use super glue to Fletch Arrows?
Once the fletching comes off, it’s pretty much worthless. Regluing them doesn’t work well. Fletch-Tight Platinum is pretty good (all I use for Blazer vanes). Super glue will work but it tends to get brittle and ineffective after a short period of time.
Can you use regular super glue on arrow inserts?
What is the best glue to use for arrow inserts?
Insert Weld Arrow Insert Glue is a Quick Bonding Rubber Toughened Agent Great for all Arrow Inserts. The Shock Resistant formula of Insert Weld has an . 008″ Gap Filler to correctly fill any insert to shaft voids. Dry in 60 Seconds, Cured in 90 Seconds with a 3700 PSI strength rating.
Are 4 Fletch arrows good?
4 Fletch Arrows. Simply put 4 vanes/feathers spins/stabilizes your arrow faster, therefore you’ll get faster trajectory and tighter groups, particularly at longer distances (distances beyond 40 yards).
https://www.youtube.com/watch?v=4bh7LOCnGiY