How many amps does a boat lift draw?
For boat lifts that operate with a ¾ horsepower motor at 110 Volts it will typically draw 12.5 Amps and at 220 Volts it will typically draw 7.5 Amps. For boat lifts that operate with a 1 horsepower motor at 110 Volts it will typically draw 14.5A and at 220 Volts it will typically draw 8.5 Amps.
Why is my boat lift not working?
Several factors can contribute to boat lift motor problems, including faulty wiring in the motor, burnt fuses, an incorrect amount of voltage to the motor, and a defective up-button, among others. A marine technician can easily repair motor problems, but a completely damaged motor will require replacing.
How many watts does a boat lift use?
For a boat lift with multiple motors, these numbers can be simply multiplied by the number of motors to determine how many Amps you can expect the boat lift to draw when operating. 3/4 HP motor running on a 110 volt generator should be 1375 watts.
How do you reset a boat lift?
Turn the unit key in either direction to reset the unit. 3. Press and hold either the “Raise Boat” or “Lower Boat” button on the remote control and reconnect the power to the Boat Lift Boss unit. A properly programmed unit will begin operation as soon as power is restored.
How do you wire a gem remote?
Connect the red wire to contact labeled “Red”, connect the black wire to the contact labeled “Blk” and connect the orange wire to the contact labeled “orange”. Finally, connect the green wire from the motor to the green wire from the GEM control’s ground. Green wires must only be used as a ground.
Are electric boat lifts safe?
Electric Shock Drowning (ESD) is a real danger. The danger is invisible, but it may be lurking within water around docks and marinas. Electricity used to power boats, dock lights and boat lifts can leak into water if not properly equipped, maintained and grounded.
How do I increase the capacity of my boat lift?
Sheaves are added to increase the capacity of the boat lift. for every sheave you add, you reduce the load on the motor and drive unit in half. The sheave needs to be routinely greased and should always be turning when the boat lift in being raised or lowered.
Should a boat lift be level?
The front and rear of your lift should be level to each other to distribute the pressure and weight of your boat more effectively. In many cases, the back legs will be longer than the front legs if the slope of the shoreline goes down, and depending on your waterfront, there might be changes between seasons.
How do you adjust a limit switch on a boat lift?
Remove Yellow cap by removing 2 screws (these will be loose from GEM Remotes) Adjustment Procedures: To adjust the upper limit use screw 2o-2(blue wire on micro switch). To adjust the lower limit use screw 2o -1(red wire on micro switch). 10: Your lift should be at the max height if you followed the directions above.