How deep should bathroom cabinets be?
The standard size depth for most bathroom vanity and cabinets is somewhere between 21-22 inches deep. Whether you’re getting a custom bank of cabinets that attach to the wall, an elegant floating cabinet, or an all-in-one vanity and countertop, this will be the depth.
How are bathroom cabinets measured?
You can use a tape measure to get the general dimensions of your bathroom vanity. Take a measurement at the widest part of the variety in contact with the the floor, which is your base width. Then, measure across the countertop, which is your top width.
What is the average depth of a bathroom vanity counter?
21 inches
The standard vanity depth is 21 inches. But you can gain floor space in a small bath by trimming at least part of the vanity to 18, 15, or even 12 inches deep.
What is standard width of bathroom vanity?
Standard widths for vanity cabinets are 24, 30, 36, 48, 60 and 72 inches, however, you may find some in-between sizes out there. The standard depth of a vanity, from front to back, is typically between 20 to 21 inches.
How much space do you need around a toilet?
Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.
How much space do you need between toilet and cabinet?
NKBA designers recommend a 30″ clearance between the front edge of a fixture, such as a vanity or toilet, and any other fixture or wall. The building code allows for a minimum of 21″.
How tall are bathroom cabinets?
32 inches
The standard height of a bathroom vanity is 32 inches or around 2.5 feet. This height has been the standard height for decades and it is very prevalent in older homes.
What is the standard overhang for a bathroom countertop?
The standard overhang for a bathroom countertop is about 1 to 1 1/2 inches from the cabinet. A bathroom countertop that is surrounded by walls is typically flush with the boundaries and has no overhang except the inch or more in the front.
What is a standard counter depth?
25 ½ inches
Countertop depth standard measure is 25 ½ inches, though this varies based on appliance depths, room size, base cabinet size, and the backsplash details. Having a standard depth countertop helps maximize your space and enhances the look of your kitchen.
How close can a sink be to a toilet?
So, it may only be possible to provide for the bare minimum clearances. In this case, make sure that the center line of the toilet is at least 15 inches from the nearest wall or sink. Eighteen inches would be preferred. Installing a pedestal sink can help give the feeling of greater room in these small areas.
How much space is needed between vanity and toilet?
A toilet should have some elbow room between it and another fixture or vanity. The NKBA’s recommendation is at least 18″. Codes allow a minimum distance of 15″.
What is the minimum size for a bathroom with shower?
30-36 square feet
In general, the smallest size is 15 square feet, which can fit a sink and a toilet. For a shower, to be installed, at least 30-36 square feet is required. For a full bath consisting of both a shower and a bathtub, you will need at least 40 square feet.
How much clearance do you need around a toilet?
How high should bathroom wall cabinets be?
Today, bathroom cabinets can still be ordered in the traditional 32-inch height for a child’s bathroom or a small adult, but most adults prefer 34 to 36 inches in height, according to the Philadelphia Inquirer.