What is a squelch tail?
It is most commonly referred to as Squelch Tail Elimination, or STE. Motorola calls their iteration of it reverse burst. In simple terms, the feature mutes or eliminates the squelch burst often heard at the end of a transmission as the PTT is released.
What is tot on Baofeng?
TOT. Limit transmission time to xx seconds. 14. VOICE. Voice confirmation of keypresses/menu selections.
What is ste on Baofeng?
Squelch Tail Elimination (STE) When Menu 35 STE is ON, the radio sends a tone of ~55 Hz for ~280 mS when the PTT key is released. This occurs even if no CTCSS encode tone is selected (Menu 13 T-CTCS is OFF). Setting Menu 35 STE to OFF disables this.
What is the difference between Ctcss and DCS?
CTCSS (Continuous Tone Coded Squelch System) uses continuous tones below 300 Hz whereas DCS (Digital-Coded System) uses digital data or encoded-words which are very unique and all encoded words can be used on the same channel without interference.
What is offset on Baofeng radio?
The offset is the difference between the repeater’s receive frequency and the transmit frequency. On the 2-meter band, the standard offset is 600 kHz. On the 70-cm band, the standard offset is 5 MHz.
What is the difference between CTCSS and DCS?
What is tot on a radio?
Time Out Timer (TOT) TOT is a timer that shuts off the radio’s transmission. Since most transmissions average 3-4 seconds in duration, a longer single transmission usually indicates an inadvertent mistake, or there’s a lengthy conversation going on that needs to be curtailed.
Should squelch be high or low?
Ideally, the squelch level should be set just above the background radio noise level or at the point where the desired signal is becoming too noisy to be acceptable. Higher settings of squelch level require higher received signal strength to unmute the receiver.
What is squelch mode?
In radio terms, squelch is the process of muting a channel when there is nothing on it. Usually, when you are on an open channel with no signal, you will hear the constant hiss of white noise which can be annoying.
What does VOX mode mean?
voice-operated exchanged
Total Hands-Free Operation VOX stands for “voice-operated exchanged”, and is sometimes also referred to as “voice activated transmission”. With VOX switched on, the microphone is always listening out for your voice. When it detects you are speaking, it will then automatically start broadcasting.
What is the purpose of offset frequency?
In radio engineering, a frequency offset is an intentional slight shift of broadcast radio frequency (RF), to reduce interference with other transmitters.
What is busy channel lockout?
The Busy Channel Lockout prevents transmission on a frequency which is, or appears to be, already in use. Normally, you’d be able to hear the other side which is transmitting using your receiver, and avoid transmitting until the channel is free.
What should squelch be set to?
What is the best squelch setting?