What connector does CB radio use?
The PL-259 coax connection is the most popular in the CB world. It has a barrel / screw-on type look, as can be seen in the picture below. All CB coax will have a PL-259 connection on at least one end, as this is the standard type of connection that plugs into the back of all CB radios.
What thread is a CB aerial?
3/8 x 24 threads
The Accessories Unlimited Standard thread CB Antenna Stud sports standard 3/8 x 24 threads. The CB5 antenna stud is stout enough to hold antennas up to 5 feet tall.
What is a PL-259 connector?
The connector design was invented in the 1930s for use in the radio industry, and is a shielded form of the “banana plug”. It is a widely used standard connector for HF transmission lines on full-sized radio equipment, with BNC connectors predominating for smaller, hand-held equipment. UHF connector. PL-259 (male) plug …
What is the difference between RG-58 and RG8X?
RG8. RG8 is a thicker 50 ohm cable, at 12 AWG, that can provide a stronger signal than RG58. It is mainly used for amateur radio. There is also a version called RG8X, which is thinner at 16 AWG but provides similar signal quality.
Does CB cable length matter?
The coaxial cable running from your radio to the antenna is VERY important. Everything you transmit and receive must travel along it’s length. All too often, the coax is ignored and performance suffers because of the lack of attention it receives. We recommend 18 feet of coax even if you don’t need that much.
What is the difference between so-239 and PL 259?
The above connectors are used in applications like amateur / HAM radio, CB / Citizens Band radio, Marine radio & VHF radio. Typically, the SO-239 (UHF Female/UHF Jack) is installed ON THE RADIO, and the PL-259 (UHF Male/UHF Plug) is installed ON THE CABLE. The two “mate” and are collectively known as a UHF Connection.
Can you use a FM radio antenna for a CB radio?
Although some devices claim that you can use your AM/FM antenna for CB, be forewarned that your CB performance will be, at best, very poor. The IM-AF does not allow you to use your AM/FM antenna for CB. Unlike the receive-only antenna needed by the AM/FM radio, a CB needs its antenna to be resonant within the CB band.
Which is better RG-58 or RG8?
RG8. RG8 is a thicker 50 ohm cable, at 12 AWG, that can provide a stronger signal than RG58. It is mainly used for amateur radio.
How long should coax be for CB radio?
We recommend 18 feet of coax even if you don’t need that much. If you use a length that is shorter or longer, you might risk having trouble achieving good SWR readings. Properly store any excess coax in a figure 8, about one foot in length, and bound in the middle- it should look like a long, skinny 8.
How long should my CB antenna be?
102 inches
Choosing the Optimal CB Antenna Length Yes, taller/longer is better for range of distance when it comes to an antenna and the optimal antenna length is 1/4 wavelength. That translates to 102 inches (8.5 feet), too tall to be practical for most mobile applications.
Does PL 259 connect to so-239?
Typically, the SO-239 (UHF Female/UHF Jack) is installed ON THE RADIO, and the PL-259 (UHF Male/UHF Plug) is installed ON THE CABLE. The two “mate” and are collectively known as a UHF Connection.
What is the difference between PL 259 and so 239?