How much end play should a torque converter have?
Converter must be free to move a minimum of 1/8″, but not more than 3/16″. If converter has no end-play, converter was installed improperly.
How many bolts does a 4L60E transmission have?
4L60E uses a 6.5″ depth bell with 6 bolts for non gen 3 LS applications and a 7″ depth bell with 7 bolts for LS applications.
What happens if torque converter is installed wrong?
When the torque converter starts malfunctioning, you may feel shuddering and even slipping in overdrive. You usually notice your car shuddering because it feels like it’s vibrating. Your car will vibrate even when you’re not going very fast. The shuddering makes the car lag and is very noticeable.
Can you shim a flexplate?
These shims are an easy way to achieve optimum spacing when installing a new flexplate on Chevrolet crankshafts. These 0.030″ shims, manufactured from high-quality steel, are a must when additional clearance is required between the starter and flexplate ring gear.
How do I know if my 4l60e torque converter is bad?
6 Signs of a Failing Torque Converter
- Loss of Acceleration.
- Slipping Between Gears.
- Vehicle Won’t Shift at All.
- Transmission is Overheating.
- Transmission Fluid Leak.
- Bad Transmission Fluid.
How do I know if my torque converter is all the way in?
My transmission guy told me a good piece of advice, he said if the converter is all the way back into the pump and the transmission is bolted to the engine, when you bolt the converter to the flywheel it should pull the converter forward 1/4″- 1/2″. This is a sure fire way to make sure it is in all the way.
Can you run a 4L60E without a computer?
Externally, all it needs is a 12-volt source and an engine-vacuum reference. However, if your trans is, in fact, a 4L60E, running it off a computer is mandatory. On “E” transmissions, the computer controls everything: TCC lockup, gear changes, shift quality and firmness, and line pressure.
Will any 4L60E work?
Both 2wd and 4wd versions of the 4L60-E can be used equally well, and there are no inherent advantages to either one once you have installed our adapter assembly. The HydraMatic can be adapted to the popular Jeep (and some IH) transfer cases, including the: Dana 18 (truck or longer wheelbase applications only)