How do I reset my Canon ink absorber full?
Press and hold the “Power” button and reconnect the power cord. When the printer comes on, release the button. Wait five seconds and push the “Power” button again. This resets the printer’s internal memory and overrides the “Ink Absorber Full” error code.
How do I fix my Canon Pixma printer Error 5b00?
Open the cartridge door and press down the Power button. Continue to hold the Power button while plugging the power cord into the wall socket. Keep holding the Power button until the printer starts resetting itself. Once all the lights are on, you may release it.
Why is my Canon printer in error mode?
If your printer’s status displays “Printer in error state,” there may be a problem with the printer itself. Make sure the printer is turned on and connected to your PC by Wi-Fi or cable. Check it for low paper or ink, and be sure the cover isn’t open and the paper isn’t jammed.
Why is my Canon printer showing error?
Canon printers produce error codes for one of several reasons: The settings for your printer might not be compatible with the document you’re trying to print. The loading bay for your paper might have become lodged with paper or you’re using the wrong type of paper.
How do I reset my Canon mp237 ink cartridge?
Off the pressure button STOP/RESET and hold pressure on the power button. On the position of the power button still depressed, you should also compensate by pressing the STOP/RESET until 6 times then release simultaneously with the power button.
What is the waste ink absorber on a Canon printer?
Canon printers feature a waste ink absorber that can cause errors if full. Canon printers feature an ink absorber pad that soaks up excess ink from the print cartridges, preventing smears and keeping the cartridge free of dried ink.
Why is my Canon printer in error state?
Why does my Canon printer Say error?
How do I clean the ink absorber pads?
- Take a bowl with warm water and add some soapy material.
- Open the ink cartridge compartment.
- wait for ink cartridges and disconnect the printers power cord.
- Look balck rubber frame under the ink cartridge.
- pull the rubber frame out of the printer and remove ink absorber pads.
- clean the pads in the bowl.
Why is my Canon printer not recognizing the ink?
If your Canon printer isn’t recognising a compatible ink cartridge, this may be because the data on the cartridge chip is stamped with an empty status before it was remanufactured. Hold down the stop / cancel button for 5 seconds to bypass the ‘ink has run out’ message and your cartridge should work.