What is gable rake trim?
Also known as rake trim, gable trim is a finishing piece of metal flashing used along the edges of a metal roof line where the edge of the metal roof panel meets the endwall panels.
What is a gable end cap?
End caps are used to cover gable trim connection at the peak of the building and finish the gable end of a post frame building. It’s manufactured from premium steel coil. Technical Specifications.
What is the difference between rake trim and gable trim?
Rake trim (also known as gable trim) is a metal flashing finishing piece placed along the roofline at the sloped sides at the end of a residence’s dormer or gable. Rake trim can be flat with no overhang, or it can overhang the gable end like an eave.
What is the metal trim around a roof called?
Eave trim is the metal flashing that covers the low side of the building. Simply put, it’s installed on the side of the building that follows the pitch of the roof. Eave trim is used when a gutter is not required. The bottom leg of the eave trim has a kick out that is designed to keep water away from the wall.
Do I need a drip edge on the gable end?
Without a drip edge, water may end up beneath the shingles and may cause damage to various parts of the home. Though your home may not have originally had a drip edge installed, drip edges are now required by most building codes across North America to protect homes from damage.
What is a gable fascia?
Fascia is trim that runs along the eaves from end to end. It’s the face, the part of the roofline you see when you’re standing in the yard. It progresses horizontally and turns 90 degrees on the angled or gabled end and runs diagonally to the peak of the roof.
What is the trim around a roof called?
Fascia
Fascia: Vertical roof trim located along the perimeter of a building, usually below the roof level, to cover the rafter tails at the eaves and to seal off the top of the siding along the rake; also called gutter boards.
Is rake edge necessary?
The rake edge should be installed at the rakes above the underlay of the roof. This is done to seal the edges of the roof and to protect the roof’s components from wind-driven rain. Installing the rake edge in this position closes off the edges of the underlayment specifically.