How high should my jointer be?
Best height will depend on your height and personal preference. I think most floor-standing jointers have tables that are 31″ – 33″ above the floor. Benchtop jointers are typically always not very wide, so you’re not going to be leaning over them, like you would a 24″ jointer, to flatten a board.
Where do you put the pressure on a jointer?
The idea is to remove material only at the ends where the board is touching the jointer. It’s even easier in this situation to press the board flat as you move it across the jointer. So it’s important to only apply pressure on the ends.
What happens if the outfeed table of a jointer is too low?
An outfeed table that is too low can lead to a different kind of problem — snipe. In this case, the jointer will work just fine through most of the cut.
What angle are jointer blades sharpened at?
25° to 45°
The Veritas® Jointer Blade Sharpener will jig planer and jointer knives and hand plane blades up to 8″ in width with bevel angles from 25° to 45°. Sharpening and adding a micro-bevel to wide blades is easy, repeatable and accurate when using the jointer blade sharpener.
What depth should the jointer be set to before the power is turned on?
Always see that the jointer is set to the right depth of cut, about 1/32 inch, before you turn on the power. If it is set too deep the work may be jerked out of your hands.
Why am I getting snipe on my jointer?
Jointer snipe occurs when the outfeed table is positioned below the jointer knives. In most jointers the height of the outfeed table is adjustable, and that makes the fix to jointer snipe a relatively easy one. Ensure that the knives are set properly.
How do I know if my jointer knife is dull?
Jointer and planer knives start to tell you that they need attention when you start to see more scaloping and it takes more effort to push the material through the jointer… especially on face jointing. The knives will be long-dull before you notice the edge!
What is the margin of safety on a jointer?
Keep your hands away from the cutterhead even through the guard is in position. Maintain at least a 6” margin of Safety!!!
Why is my jointer not cutting straight?
Most out of square problems can be traced to fence alignment issues. The first step in fixing this problem is to do a simple check of your fence. Using an accurate square, check your fence at several points along its length to make sure that it’s truly square to the jointer tables.