What tanks fit the cool fire IV?
Compatibility. The CoolFire IV vapes perfectly with the Innokin iSub Apex & iSub-G Sub Ohm tanks.
Why does my cool fire IV says shorted?
A ‘Shorted’ or ‘Check Atomiser’ error message means somewhere in the device’s connection, the atomiser is causing an electrical short circuit. To resolve the issue, you will need to replace the coil in the tank. It doesn’t necessarily mean it’s an incompatible coil.
How do you change innokin to Watts?
To switch to wattage mode hold the power button and the plus button together. Similarly, to switch to voltage mode hold the power button and the minus button together. The wattage ranges from 6W right up to a whopping 40W in 0.5W increments, whilst the voltage ranges from 3V to 7.5V in 0.1V increments.
How do I change my CoolFire IV to Watts?
To switch to watts, hold down the fire button at the same time with “+” button. If you want to enter Variable Voltage mode, hold the fire button and “-“ button down together.
How do I change my CoolFire IV TC100?
The CoolFireIV TC100 wattage can be adjusted from 6.0 to 100 watts in . 5 watt increments by pressing and holding the “+” or “-” button. Hold the button down to quickly increase or decrease the set wattage. If the wattage is decreased below 6 Watts it will cycle up to 100 Watts.
How do I fix my vape atomizer?
Recap
- Clean all contacts on battery/mod, tank or pod.
- Remove and reinstall the coil (after cleaning)
- Try a new coil.
- Check the 510 pin and see if you can adjust it (mods/tanks)
- Try another tank on your mod.
- Try another mod with your tank.
- Adjust base of coil carefully if you can (mainly sub-Ohm coils)
How do I clean my vape atomizer?
To carry out this method, simply submerge your atomizer in some isopropyl alcohol for 30-60 minutes. This will cause the hardened dirt to become saturated and it will break down and pull away from the atomizer when you wipe it down with your cotton buds.
How do you fix a short circuit on a vape?
Here are a few things to try to resolve atomizer short:
- Make sure the batteries are charging them properly by putting them in a separate charger.
- If using an RDA/RTA, check and see if the coil is touching the cap or deck.
- See if there are any breaks in the coil.
- Ensure that the coil is fully screwed into the tank.
How do I change my innokin settings?
Should you wish to change the setting, hold either the “+ or -” button for a few seconds until the current power setting starts flashing then let go. Once the display is flashing, you can increase or decrease the setting as required. The display will cycle from 6.0W to 40.0W (in 0.5 steps).
How do I change my innokin vape?
Why is my vape tank not working?
Reseat your Coil/Pod If your pod vape uses replaceable coils you can try removing the coil and reinserting it into the pod. Ensure that you’re lining up the coil properly if there are any notches that need to be lined up and that the coil is snugly, firmly, and properly seated in the pod.